The RME-A11 and RME-A89 ecus are found in the 2007-2008 GD Honda Fit and Honda Jazz and can be found behind your passenger side glovebox, mounted above the lower dash cover. The Honda Fit ECU is easily removable and shares many of the same pinouts as the 2001+ EP3 Honda Civics.
As always, make sure to disconnect your battery before conducting any work on the wiring or the relays connected to your ECU/PCM. Our article on Honda Fit ECU Pinouts is always a work in progress so if you need a pin or wire identified let us know so we can add it to our Honda Fit ECU Pinouts.
Lets begin with Connector A a 31 pin block with the most connections that would be relevant for any kind of wiring install.
- Pin 1 – Red/Blue wire – Knock Sensor
- Pin 3 – Yel / Black wire – IGP Power 1
- Pin 4 and Pin 5 – Black wire – Ground
- Pin 30 – Red/Green – MAP Signal
- Pin 28 – Red ( AFS – )
- Pin 18 – Manual transmission only – (VSS)
Moving onto Connector B a 24 pin terminal
- Pin 2 – Yellow – Injector 4
- Pin 3 – Blue – Injector 3
- Pin 4 – Red – Injector 2
- Pin 5 – Brown – Injector 1
- Pin 17 – Red/Yellow – Intake Air Temperature
Next is the Connector C a 22 pin terminal
- Pin 1 – Brown/White (LSB)
- Pin 2 – Green (SHC)
- Pin 9 – Red (ATPD3)
And lastly the Connector D a 17 pin terminal
- Pin 5- Blue Orange ( APSB)
- Pin 6 – Purple – APSA
This does it for our Honda Fit ECU Pinouts article, please let us know if you need any further pins by commenting below!
Happy Tuning!
- Pro Street Staff
- www.prostreetonline.com
- 1-888-776-7022
I need to know wich pinout is for the v-tec control in The RME-A11 and RME-A89 ecus are found in the 2007-2008 GD Honda Fit and Honda Jazz and can be found behind your passenger side glovebox, mounted above the lower dash cover. The Honda Fit ECU is easily removable and shares many of the same pinouts as the 2001+ EP3 Honda Civics
Hi Maria, thanks for reading.
no problem.. did you check our SAFC guide in a Honda Fit here :
http://my.prostreetonline.com/2014/10/22/install-safc-honda-fit/
if not, just let us know what wire you are after, VTEC pressure switch or the VTEC solenoid. Thanks for commenting!~
I need to know the Ignition wire 12 V wire and the ground Wire just need the color layout so I can install be our Revlimiter
Hi James, you can take both directly off the steering column / ignition switch of your Fit.
Please . I need honda fit 2007 ecu control wiring diagram.
Hi, we’ll get this posted soon! Thank you for your Honda Fit ECU request!
Would have the s02 sensor pin out for wideband for flashpro??
Hi Dave, are you talking about the downstream 02 sensor in your Fit? If so sir, no this is still a narrowband and it wouldn’t give you the 0-5 volt signal you are after in the wideband. Let us know if this was your question. Thanks for commenting!
Good information!!…I need pin out for the fuel pump relay in the other 31 pin block
thank you
I need A/C pinouts (c9mplete diagram for how to do witing for Air conditioning system with evaporator below and ac temperature thermostat) for L13A engine with non-electronic throttle body with cvt gear for honda fit 2004