mitra

I bought onsoku adjustable cam gears and stage 3 cams for d16a9/zc engine.Now is the question how i need to adjust cam gears?Crespo told me that when i assamble them on engine that i need to:
Intake Valve Lift @ TDC Overlap 2.30mm
Exhaust Valve Lift @ TDC Overlap 1.30mm
What is that mean?Is that maybe when i put my engine in tdc that i need to adjust cam gears in +intake 2.30mm and exhaust +1.30mm how will i now how much is that on cam gears because there are degrees each mark is 2degrees on crankshaft.Can anyone explain how that exatcly goes??thanks

deep_stage_srt4

when you bought the cams, did you get new lifters, rockers , bearings etc...? and the best place to adjust your cam gears is on a dyno, man i can only warn you once that if you advance or retard those gears too much and you put a valve into your piston, im only going to say i told you so. if you have no clue what your doing, take it to someone that does! the only place i would suggest adjusting your cams at is on a dynometer. your only guessing otherwise.

__________________
There is no replacement for displacement, like a turbo! -dssrt4

**Sponsored By **