JDMJNKY

Bored today & I had the day off, so Here's the beginning of my LMA assembly for those of you who plan to attempt the same thing! My Valves, springs & retainers etc, were not removed from the head. If you have any thoughts, or edits feel free to correct me! This is my cyl head cherry......POP!:thehump:

Materials needed:
Red Line assembly lube ( in my case 5w30 & a liquid detergent cap)
12mm
10mm
Straight edge (in my case , my left eye)


OPTIONAL:
Valve adjustment nut tool (avail. through snap-on, etc)
Feeler Gauges

1. Make sure head is clean (have it checked by your local shop if need be)


2. Lubricate cam bearing area, & gallies



3. Pour oil all over cam make sure it is heavily lubricated (this step works best w/ assm. lube, :slap keeps work area cleaner! install cam very gently, make sure cam aligns w/ cam bearing area. USING A STRAIGHT EDGE TO MAKE SURE CAM IS AT TDC _ markings should look like >>> - UP -



4. Add rocker assebly. I have no pics, BUT YOU MUST MAKE SURE THAT THE LIFTERS LARGEST POLISHED SQUARE AREA/SIDE FACES DOWN TOWARDS CAM & THE SMALL TAB FACES UPWARDS NEAR INTAKE MANIFOLD SIDE! If it is done correctly you will know exactly what I'm speaking about!

5. Add Motion assemblies, cap & 12mm bolts, hand tighten. then add the 4 10mm bolts and hand tighten...once all tightened torque to spec each d-series will be different,
12mm bolts 14 ft lbs.
10mm bolts 11, 12, 13, 14 8.7ft lbs.


6. Now adjust valve lash according to engine setup...
Factory .007 Int .009 exh.

__________________
"...If you hold a fistful of sand tightly in your hand it will slowly escape.....but if you hold that same fistful of sand loosely, you can keep it there as long as you desire!!!"

R.I.P JON "KWITE" GIL

jdm KIDS..................BIOAATCH!!

MY REBUILD

DaBiGZ

sweeet, on a 3 stage - it's a bi yatch holding all da lil "pill" locks in the rockers (int side) I used a wire hanger to hold it all together until install finally,yup! Good writeup again,yo!

John@ProStreet

nice writeup, good work

__________________
Pro Street Motorsports
www.prostreetonline.com

Ultimate Street Car???

Pro Street goes to SEMA

JDMJNKY

lol...yeah these lil bastards kept sliding out , it just takes finess!

__________________
"...If you hold a fistful of sand tightly in your hand it will slowly escape.....but if you hold that same fistful of sand loosely, you can keep it there as long as you desire!!!"

R.I.P JON "KWITE" GIL

jdm KIDS..................BIOAATCH!!

MY REBUILD

GSRTURBO

SOHC FTW

__________________
-Brandon
DD '92 Civic VX - B18C1 swap - 8spi t04r