JDMJNKY

here are some pics of the BG finally installed! 20 min ago!!!!

Brief blockgaurd how to:
Install time 10 min.
skill level: B
Tools: Rubber mallet/ dead blow, Dowel pin

Set the gaurd evenly/square onto the block, gently press it down by hand to get a rough idea of fitment....


USING A RUBBER MALLET (RUBBER DEADBLOW)gently begin to tap it in from the center out (cyl. 2, 3, 1, 4) until it lays flush with the block


If you are not skilled i dont advise this part w/ the following tools you may see.....( unskilled pls. prepare: wire hanger [if you go too far], a dowel pin larger than cooling wholes, and a priest w/ some holy water!!)

In the same fashion begin to tap the gaurd gently down w/ dowel (in my case philips screw driver) until desired depth is reached 1.5mm - 2mm. must be either or depth, even all the way around, not 1.5 here & 2 there!






FINISHED PROD.FINALLY REMOVE ALL DEBRIS

__________________
"...If you hold a fistful of sand tightly in your hand it will slowly escape.....but if you hold that same fistful of sand loosely, you can keep it there as long as you desire!!!"

R.I.P JON "KWITE" GIL

jdm KIDS..................BIOAATCH!!

MY REBUILD

GSRTURBO

nice work

__________________
-Brandon
DD '92 Civic VX - B18C1 swap - 8spi t04r