FAQ – Honda Fit Ecu Pinouts

FAQ – Honda Fit Ecu Pinouts

10
SHARE

The RME-A11 and RME-A89 ecus are found in the 2007-2008 GD Honda Fit and Honda Jazz and can be found behind your passenger side glovebox, mounted above the lower dash cover. The Honda Fit ECU is easily removable and shares many of the same pinouts as the 2001+ EP3 Honda Civics.

honda_fit_ecu_position

 

As always, make sure to disconnect your battery before conducting any work on the wiring or the relays connected to your ECU/PCM. Our article on Honda Fit ECU Pinouts is always a work in progress so if you need a pin or wire identified let us know so we can add it to our Honda Fit ECU Pinouts.

fit-604x165

 

Lets begin with Connector A a 31 pin block with the most connections that would be relevant for any kind of wiring install.

  • Pin 1 – Red/Blue wire – Knock Sensor
  • Pin 3 – Yel / Black wire – IGP Power 1
  • Pin 4 and Pin 5 – Black wire – Ground
  • Pin 30 – Red/Green – MAP Signal
  • Pin 28 – Red ( AFS – )
  • Pin 18 – Manual transmission only – (VSS)

Moving onto Connector B a 24 pin terminal

  • Pin 2 – Yellow – Injector 4
  • Pin 3 – Blue – Injector 3
  • Pin 4 – Red – Injector 2
  • Pin 5 – Brown – Injector 1
  • Pin 17 – Red/Yellow – Intake Air Temperature

Next is the Connector C a 22 pin terminal

  • Pin 1 – Brown/White (LSB)
  • Pin 2 – Green (SHC)
  • Pin 9 – Red (ATPD3)

And lastly the Connector D a 17 pin terminal

  • Pin 5- Blue Orange ( APSB)
  • Pin 6 – Purple – APSA

81

 

This does it for our Honda Fit ECU Pinouts article, please let us know if you need any further pins by commenting below!

Happy Tuning!

10 COMMENTS

  1. I need to know wich pinout is for the v-tec control in The RME-A11 and RME-A89 ecus are found in the 2007-2008 GD Honda Fit and Honda Jazz and can be found behind your passenger side glovebox, mounted above the lower dash cover. The Honda Fit ECU is easily removable and shares many of the same pinouts as the 2001+ EP3 Honda Civics

    • Hi Dave, are you talking about the downstream 02 sensor in your Fit? If so sir, no this is still a narrowband and it wouldn’t give you the 0-5 volt signal you are after in the wideband. Let us know if this was your question. Thanks for commenting!

  2. I need A/C pinouts (c9mplete diagram for how to do witing for Air conditioning system with evaporator below and ac temperature thermostat) for L13A engine with non-electronic throttle body with cvt gear for honda fit 2004

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.